Trade toughened safety glass in Cheshire

Ordering toughened safety glass for jobs in Cheshire

For balustrades and structural uses, the glass type and thickness should come from the system designer or engineer, not chosen on site.

Toughened glass cannot be cut, drilled or edged once it has been toughened. Every hole, notch and cut-out must be on the order before processing.

Specification at a glance

• Holes, notches and cut-outs before toughening
• Safety marking on each piece
• Thicknesses typically from 4mm to 12mm
• Clear, low-iron, tinted and obscure options
• Toughened to BS EN 12150

Delivery across Cheshire

For Cheshire, delivery is to your site, yard or unit. Tell us about any access limits, such as weight restrictions or narrow streets, so the right vehicle is booked.

Building regulations in England

Under Approved Document K, glazing in critical locations (doors, and side panels within 300mm of a door, up to 1500mm above floor level; other glazing below 800mm) must break safely, be robust or in small panes, or be permanently protected. Toughened and laminated safety glass are classified to BS EN 12600. Replacing only the glass in an existing frame is generally treated as a repair rather than notifiable work.

Before anything goes into production you get a written order acknowledgement with sizes, finishes and handing for every item. Check it carefully, because made-to-measure items cannot be returned if the sizes were wrong.